Flat wire forms · 2–6 mm
CNC 2D Wire Bending Machine
Feeding, straightening, bending and cutting for repeatable flat wire components. Final configuration depends on the wire, geometry, tolerance and output requirement.
Send Your Product Drawing →Product fit first
Use it when the part is formed in one plane.
This machine family is intended for repeatable flat forms produced from coil wire. Product geometry, material behavior and end requirements determine tooling and machine configuration.
- Flat hooks, brackets, guards and frame components
- Coil feeding with straightening before forming
- Programmed bending sequence and cut-off
- Tooling configured around the approved part
Send for fit review
- Dimensioned product drawing or physical sample
- Wire material and diameter
- Required tolerance and surface condition
- Target output and downstream process
Configuration
boundaries.
These are selection inputs, not universal performance promises.
| Confirmed wire range | 2–6 mm |
|---|---|
| Primary process | Feeding, straightening, 2D bending and cutting |
| Typical product type | Flat wire forms, hooks, brackets and frame components |
| Configuration inputs | Material, diameter, geometry, tolerance, output and downstream operation |
| Customizable items | Tooling, feeding arrangement, forming sequence and compatible automation modules |
Check this machine against your part.
Send the drawing, material, diameter and target output.